N-Gear MOVE WASH LIGHT 7 Manual De Usario página 5

Setting Maximum Tilt Angles
To select , use the "MODE 'ESC"button and choose "t. 9","t. 18""UP"and "DOWN"buttons cycle
between all available Tilt Angles . Press the "ENTER"button to confirm the chosen selection.
LED Display Maximum Pan
t.9 90°
t.18 180°
In built Program Mode (continued)
As the unit can be mounted hung under earth trussing, or can sit equally well on a flat surface , pan ,
tilt and LED display settings can be reserved to provide correct coverage and ease of use.
Setting Reversed or Normal Pan
To select . use the "MODE, ESC"button and choose "Pan"(normal) or, Pan"(reversed). "UP"and
"DOWN"buttons cycle between the two settings . Press the "ENTER"button to confirm the chosen
selection
Setting Reversed or Normal Tilt
To select , use the "MODE, ESC"button and choose "t. L"(normal. I" (reversed). "UP"and
"DOWN"buttons cycle between the two settings. Pressing the "ENTER"button to confirm the chosen
selection
Setting Reversed or Normal LED display
To select , use the "MODE, ESC"button and choose "d. s"(normal)or"rd. s"(reversed). )."UP"and
"DOWN"buttons cycle between the two settings . Pressing the "ENTER"button to confirm the chosen
selection
Auto Run Mode
one of two Auto Run Sub-nodes can be selected with a choice of preset speeds. This mode enables
the unit to act as a Master to other Slave units Choosing Auto Run Sub-nodes
To select , use the "MODE .ESC"button to show "NAFA"or"NASL"."UP"and "DOWN"buttons Change
between the two initial options. With the appropriated option selected, use "ENTER" to confirm and
the LED Display with change to:"Fast ( fast)-or Slow"(slow). The unit will then run at the chosen speed
Initial LED Display
NAFA
NAFL
Second LED Display
FAST
SLOW
Sub mobe
FAST AUTO RUN
SLOW AUTO RUN