Pro-Lift T-5310 Instrucciones De Operación página 3

PREPARATION
Inspect lift before each use:
1. Before using this product, read the owner's manual completely and familiarize yourself thoroughly with the product
and the hazards associated with its improper use.
2. Verify that the product and the application are compatible. If in doubt, contact Pro-Lift Customer Service.
3. Owner and operators of this device shall be aware that no serviceable or replaceable parts are available for this
device other than those parts listed on page 6.
4. Do not attempt to weld, rivet or otherwise repair this device.
Right Wheel Track
ASSEMBLY
1. Remove the product from packaging, ensure all components are accounted for (see figure 1).
Notice: Attachment springs are pre-assembled to each wheel track using the Phillips Screws, Flat Washers and
Locknuts
2. Remove Hairpin Clip and Clevis Pin from Stopping Plate, and attach Stopping Plate to Wheel Track (see figure 2).
Left Wheel Track
Figure 1 - Push Mower Adapter Nomenclature
Figure 2 - Assembly of Stopping Plate to Wheel Track
Attachment Spring (x4)
3
Clevis Pin (x2)
Stopping Plate (x2) Hairpin Clip (x2)
Phillips Screw (x4)
M6 Nylon-Insert
M6 Flat Washer (x4)
Locknut (x4)
M6 x 1.0