Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS
Generally
Telesteps
®
is a telescopic ladder, that by it´s
unique construction, extends from a compact
format (Illustration
) to, either full length
1
(Illustration
), or any intermediate length
2
(Illustration
).
3
The Telesteps telescopic ladder must be
handled, cared for and maintained in
accordance with the following instructions.
Locking mechanism
The Telesteps ladder locks at every step with
two steel locking pins that automatically
spring into place when the ladder is opened
(extended).
Each locking pin is connected to a locking
lever (Illustration
), that has two functions:
4
◆ to indicate that an opened ladder is
securely locked, both locking levers under
each step drop DOWN at an angle of
approx. 60 degrees, in relation to the
step (Illustration
5
◆ when closing the ladder, the locking levers
will release the locking mechanism auto-
matically, as each section is lowered.
Opening the Ladder
Full length
To open the Telesteps telescopic ladder to its
full length, proceed as follows:
◆ The ladder is opened to its full length by
placing it on a firm level surface. During
opening, stabilise the ladder with one
foot placed on the lower step
(Illustration
).
6
◆ Open the ladder from the top by gripping
the top step with both hands. Extend the
top section fully, then extend the next
section fully. At the same time check that
both locking levers (Illustration
)
7
-A-)
drop DOWN at an angle of 60 degrees in
relation to the step (Illustration
◆ Continue opening section by section,
until the ladder is opened to its full length
(Illustration
).
2
◆ Please Note that the 2nd step from the
bottom has locking levers with pull rings.
These work in reverse to the other
levers (Illustration
the section is locked when locking levers
are in an UPWARD position and fully
inserted in the step. Only the pull rings
can be seen under the step.
NOTE! Check carefully that the locking
levers with pull rings are in a locked
position.
Intermediate length
To open the Telesteps telescopic ladder to
any intermediate length, proceed as follows:
◆ The ladder is opened to any intermediate
length, by placing it on a firm level
surface. During opening, stabilise the
ladder with one foot placed on the lower
step (Illustration
◆ Open the ladder by gripping around the
step, which you choose to be the upper
step (example – Illustration
this section fully by pulling upwards.
◆ Thereafter, continue with one section at a
time, until all sections below are extended
fully (Illustration
10
remaining sections, which are not used
for the length you have chosen, are
packed together on the top of the ladder
(Illustration
B).
10
◆ Check carefully, that both locking levers
on each step drop DOWN at an angle of
approx. 60 , in relation to the step at
each section (Illustration
Notice that the 2nd step from the bottom
have locking levers with pull rings. These
7
5
).
8
). They indicate that
).
6
9
), and extend
), and where the
5
and
A).
10
GB
Publicidad
Tabla de contenido
