Tabla de contenido
Publicidad
COMPONENTS
1.
Carrying Handle
2.
Lifting Eyelet
3.
Chimney
4.
Side Piece
5.
Glass with Wire Support
6.
Handle of the Wire Support
7.
Burner with Wick
8.
Rotating Handle
9.
Tank Lid
10.
Tank
DEUTSCH
ENGLISCH
FRANÇAIS
HOW TO USE
FILL WITH FUEL
Open the tank lid and fi ll the tank of the
lantern with lamp oil. Fill with fuel just to
the bulge (see marking on fi gure 1). Before
the fi rst use, the wick needs to soak in fuel.
Therefore, wait for about 20 minutes after
adding adding fuel to the lantern before
lighting it.
LIGHTING THE LANTERN
Lift the glass cylinder of the lantern by pres-
sing the handle on the left side and hooking
it in the notch provided. Light the wick, which
should stick out of the burner by about 1 to
2 mm, with a lighter or a match. As soon as
the wick burns, slowly replace the glass by
means of the respective handle. (Figure 2)
ADJUSTING THE WICK
You can adjust the size of the fl ame by tur-
ning the rotating handle of the burner. (Figure
3) The fl ame should not fl icker or emit soot.
The recommended size of the fl ame is bet-
ween 1.5 to 2 cm. The fl ame becomes extinct
when the wick is turned downwards. Make
sure the fl ame has really stopped burning by
turning the wick upwards again. Advice: Do
not turn the wick down too far, otherwise it
could lose its grip in the burner.
ESPAÑOL
中文
中文
Publicidad
Tabla de contenido
