FRIEDLAND D524S Manual De Instrucciones página 3

D524S 46360PL_Ed1 5/6/05
8. Sound Selection & Volume adjustment
A = Main push sound selection
B = Second push sound selection
Tunes options are as follows:
Sound Variety:
1. Mini Bell 8 Note (Default Tune for 1st Push)
2. Mini Bell 4 Note
3. Mini Bell 2 Note (Default Tune for 2nd Push)
4. Mini Bell 1 Note
5. Soprano sax
6. Tone Bar 2 Note
C
A
B
Fig. 5
9. Fitting the door chime
The door chime mounting height
should be around 2 m (6 ft)
from ground as shown in Fig 6.
Follow the TOP arrow as shown
in Fig 7. The distance between
both mounting holes is 96 mm
as shown in Fig 7.
The chime base should be wall
mounted using the screws and
wall plugs provided (refer to Fig 7
for mounting information).
Fig. 8
7:09 AM Page 3
The Volume adjustment
knob (C in Fig 5) enables
you to adjust the volume
of your door chime at any time.
Fig. 6
96mm
TOP
Fig. 7
Screws
10. Refit chime cover
After the automatic programming,
sound selection and volume
adjustment is finished, press the
decorative cover back onto the
installed Chime Base as shown in Fig 8.
11. Replacing Batteries
First remove decorative cover
and replace with 3 x LR14 (C)
alkaline batteries.(Fig 9)
When replacing batteries the
chime is still programmed
and can be used straight away.
Trouble Shooting
Chime not Sounding
Batteries may not be inserted correctly
Check all batteries have been inserted correctly
Chime may be positioned out of range of the bell push
Move your chime closer to the bell push
Note: During the programming cycle the transmission range may be reduced.
The chime will resume optimum range after 5 minutes
A metallic object may be blocking the signal from bell push position
Experiment with the location of the chime to see if you can move it in a
more suitable place
The battery in the bell push may need replacing
Press the bell push. If the confidence light (D) flashes 5 times after being
pushed, replace the battery
2 m
6 f t
Note: In cold conditions, poor location or environment, operating at maximum
range it is advisable to replace the battery more frequently before the indicator
light flashes (i.e every 12 - 18 months) to maintain optimum performance
Your bell push and chime haven't been programmed
Do the automatic programming of your chime and bell push
Novar ED&S hereby declares that this wirefree product is in compliance with
the essential requirements and other relevant provisions of the Radio and
Telecommunications Terminal Equipment ( R & TTE ) directive, 1999/5/EC
Friedland guarantees this product for 3 years from date of purchase.
Proof of purchase required, this does not affect your statutory rights.
If you require further information about our products, call the Friedland helpline
on 01268 563066.
Friedland, The Arnold Centre, Paycocke Road, Basildon, Essex,
SS14 3EA, England www.friedland.co.uk
-
+ -
+
-
+
Fig. 9
Declaration
GB