Publicidad
STEP 7: LEVELING THE MONITORS
After the monitors are installed on the crossbar, there may be a small height difference between
them. To align the monitors, use the adjustment screw located on top of the monitor tilt.
1. To raise a monitor, turn the screw clockwise. To lower, turn counter clockwise.
2. If the adjustment bottoms out before reaching alignment, move the second
monitor in the opposite direction.
STEP 8: WEIGHT ADJUSTMENT
Your monitor should move up and down easily and stay in
place once adjusted. If it is difficult to adjust or moves
without assistance, it is not properly balanced.
M8.1 Arm - Total Weight Range: 6-28 lbs. (2.7-12.7 kg)
Single Monitor - Max weight: 28 lbs. (12.7 kg)
Dual Crossbar - Max weight per monitor: 12.5lbs (5.6 kg)
1. Press the Upper Arm Link (A) downward until Adjustment
Screw (B) is visible.
2. If the arm rises up on it's own, the lift force is too high and can
be decreased by rotating the Adjustment Screw counterclock
wise (towards -) with a 5 mm hex key. If the arm falls down
with the weight of the monitor, the lift force is too low and can
be increased by turning the Adjustment Screw clockwise
(towards +).
3. The current counterbalance setting can be seen through the
counterbalance indicator (C) on top of the upper arm. This
information can be used to quickly set multiple arms to the
same level without needing the monitors to be installed.
CAUTION: Do not over tighten the screws as it can damage
the screw head or threads.
①
(DUAL-MONITOR APPLICATION ONLY)
②
③
C
A
B
7
Publicidad
