Publicidad
Idiomas disponibles
Idiomas disponibles
Step 9 - Install Ground Wire to Front Left Leg Stud.
Attach the ring connector end of the ground wire as follows:
a) Using pliers or an adjustable wrench, remove the front leg mounting nut
from the front left leg bracket.
b) Place the ground wire ring connector over the stud.
c) Reinstall the nut with ring connector attached in the same location from
which it was removed.
Step 10 - Reinstall Battery, Battery Cap, and Grease Tray
Insert the battery into the Electronic Ignition Module with the negative (-) end
first, as shown and reinstall the battery cap.
Reinstall grease tray.
Step 11 - Verify Proper Operation
Press the ELECTRONIC IGNITION button on the battery cap to verify a
rapid spark, which should be audible.
Step 12 - Apply New Lighting Instruction Label
Apply the new lighting instruction label (supplied in this repair kit) to the
bottom shelf. Be sure to completely cover the obsolete lighting instructions.
New Label
6
Front leg mount stud
Front left leg
Ground Wire
Front leg mount nut
-
Press Ignition Button
9
10
+
11
12
Publicidad
