Publicidad
A
Function
Intake float
Float valve
strainer
Telescopic tube
Assemble surface skimmer as per drawing. Pay attention to easy
movement of intake valve.
B
Installation
Place the skimmer in the aquarium in such a way that the intake
float lies on the surface of the water at an angle of approx. 45°. Pull
up float valve approx. 1 cm to begin skimming. Connect the skimmer
to the suction side of filter with hose.
C
In the case of filters 2215/17, 2226/28, 2250, 2260, 2315/17
and 2326/28, a T- reducing piece is necessary, so that a by-
pass is created (see illustration).
If the output flow of the filter is too high, a rattling of the valve may
occur. In this case too it is advisable to install a bypass (see ill. C).
D
Attention
The direction of flow must be towards the skimmer, i.e. surface
skimmer must be positioned on the opposite side of the aquarium
to the spray bar.
E
To shut off the intake float push float valve down. (feeding etc.)
In the case of young or small fish, only use the skimmer for
short periods. 10 minutes a day is sufficient.
Temporary foaming in the inlet pipe does not reduce the efficiency
of the skimmer or the filter.
A distance spacer is available for bridging large aquarium frames
(order no. 4004560).
Français
Consignes de sécurité
Avant de plonger la main dans l'eau de l'aquarium, couper du
secteur tous les appareils électriques.
Pour les thermofiltres, commencer toujours par retirer la fiche
du chauffage. Ne jamais couper les câbles électriques.
Fonction
A
Flotteur d'entrée
Crépine d'aspiration
Assembler l'aspirateur de surface comme indiqué sur le dessin.
Veiller à ce que la soupape s'actionne facilement.
Assemblage
B
A l'aide de la fixation à ventouse, placer l'appareil dans l'aquarium
Intake valve chamber
Suction cups.
Languette d'arrêt
Tube téléscopique
Intake
Chambre de soupape
Fixation à ventouse.
Publicidad
