Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Cut 3" long pieces of shrink wrap tubing, slide it
over black lead from Cord Assembly and yellow wire
from Power Switch.
5.
Solder black and yellow wires to connection on Sup-
pressor leads. See Wiring Diagram.
6.
Slide heat shrink tubing over soldered connection and
heat shrink.
Fuse Holder
1.
Insert Fuse Holder into hole in Chassis Assembly.
2.
Tighten locknut to secure Fuse Holder.
3.
Cut two small pieces of heat shrink tubing and slide
one piece of tubing over each yellow wire.
4.
Solder yellow wires to connections on Fuse Holder
using same locations as when disassembled. See
Wiring Diagram.
5.
Slide heat shrink tubing over soldered connection and
heat shrink.
Receptacle
1.
Route wires through large hole in Chassis Assembly.
2.
Cut three small pieces of heat shrink tubing and slide
one piece of tubing over each wire.
3.
Solder wires to Receptacle using same locations as
when disassembled. See Wiring Diagram.
4.
Slide heat shrink tubing over soldered connections
and heat shrink.
5.
Insert Receptacle into hole in Chassis Assembly,
align spacer, and secure in place with Receptacle
Screws.
Transformer
1.
Attach Transformer to Chassis Assembly with Trans-
former Screw Washers and Transformer Screw Nuts.
Be sure to attach green ground wire.
2.
Solder wires to Transformer using same locations as
when disassembled. See Wiring Diagram.
Forward/Reverse Switch
1.
Place Forward/Reverse Switch in Control Base Plate,
making sure that posts on bottom of Switch fit into
holes in Control Base. Be sure that switch orientation
is correct.
MAINTENANCE SECTION
2.
Power Switch
1.
2.
3.
4.
5.
6.
7.
Control Base
1.
2.
3.
4.
Cover
1.
2.
3.
4.
19
Solder Forward/Reverse Switch posts to bottom of
Control Base. Use care to avoid damage to Control
Base.
Pull yellow Power Switch wires through Control
Base and Control Base Switch Plate.
Cut two small pieces of heat shrink tubing and slide
one piece of tubing over each yellow wire.
Solder wires to Power Switch in same location as
when disassembled.
Slide heat shrink tubing over soldered connection and
heat shrink.
Place Power Switch in Control Base Switch Plate
making sure that post on Power Switch fits into hole
in Control Base Assembly.
Attach Power Switch to Control Base Switch Plate
with Power Switch Screws, Power Switch Screw
Washers and Power Switch Screw Nuts.
Solder post of Power Switch to bottom of Control
Base. use care to avoid damage to Control Base.
Replace Power Switch. Refer to ASSEMBLY:
Power Switch.
Carefully solder wires to proper connections on Con-
trol Base. See Wiring Diagram.
Attach Control Base to Left Side Plate (3A) with
Control Base Screws.
Attach control Base to Right Side Plate (3B) separat-
ing Suppressor from Control Base with Suppressor
Spacers and Suppressor Screws.
Align post on front of Cover with hole in front of
Chassis Assembly.
Snap Cover in place over locking tabs at back of
Chassis Assembly.
Secure Cover with the four Cover Screws.
Replace Torque Knob.
Publicidad
Tabla de contenido
