EHEIM compact+ 2000 Manual De Instrucciones página 8

D Care and cleaning
Disconnect the pump from the mains supply. Remove the suction grid from the pump.
Unscrew the four screws and remove the pump housing towards the front.
Remove the complete pump wheel unit (Model 5000) or axle with sleeves (Models
2000 /3000). Thoroughly wash all the pump parts and clean them with the EHEIM brush
set (order No. 4009560).
Inspect the sealing ring on the motor body for signs of dirt and for correct position.
Renew the sealing ring if it is damaged.
Finally, reassemble all the parts in the reverse sequence.
– Check that the voltage shown on the label of the unit corresponds to the voltage of
the mains supply.
– Disconnect all electrical appliances from the mains before placing hands in the water.
– The line cord of this unit cannot be replaced or repaired. Should the line cord be-
come damaged the appliance must be discarded.
– Close supervision is necessary when any appliance is used by or near children.
– To avoid injury, do not contact moving parts.
– Always unplug an appliance from an outlet when not in use, before putting or
taking off parts, and before cleaning. Never yank cord to pull plug from outlet.
Grasp the plug and pull to disconnect.
– Do not use an appliance for other than intended use. The use of attachments not re-
commended or sold by the appliance manufacturer may cause an unsafe condition.
– Read and observe all the important notices on the appliance and its cord.
– Care should be taken to arrange the cord so that it will not be tripped over or pulled.
– DANGER. To avoid possible electric shock, special care should be taken since water
is employed in the use of aquarium equipment. For each of the following situations,
do not attempt repairs yourself; discard the appliance.
• If the appliance shows any sign of abnormal water leakage, immediately unplug it
from the power source.
• Do not operate any appliance if it has a damaged cord or plug, or if it is malfunc-
tioning or if it is dropped or damaged in any manner.
• To avoid the possibility of the appliance plug or receptacle getting wet, position
aquarium stand and tank to one side of a wall mounted receptacle to prevent wa-
ter from dripping onto the receptacle or plug.
VERY IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.