Important Safety Notice - Joycare JC-506 Manual De Instrucciones

JC-506
GB
HAIR CLIPPER JC-506
INSTRUCTION MANUAL
Congratulations on having purchased the Joycare Hair Clipper JC-506 Please, before starting using
this appliance, read carefully the following instruction
manual.

IMPORTANT SAFETY NOTICE

- Before connecting the appliance to the mains, please check if the voltage of your DC socket
corresponds to the one stating in the rating label.
- Never use the product in the bathroom or in other wet places.
- In order to avoid electric shocks, it is advisable not to submerge the product into water or into other
substances; if the product should accidentally fall into water,
NEVER try to reach it and unplug immediately the product.
- NEVER use the appliance if you are in direct contact with water: inside the bath, with water running
in the basin or with wet hands.
- High supervision is recommended in case the product should be used by children and invalids.
- Always keep the cable away from heating sources.
- When you store the product, it is advisable not to wind the cord round the appliance.
- Never try to unplug the product pulling it from the cable or from the product
itself.
- In case of damages to the cable or to the product, it is necessary to stop immediately using the
product and address to authorised centres.
- Never try to repair the product by yourself.
- In order to avoid the product from possible overheating, it is advisable to unwind completely the
cable and not to keep the product turned off it is not in use.
- In order to avoid possible risks and damages, never use the product for purposes other than those
showing in this instruction manual.
- In case the product does not function properly, stop immediately using it and address to authorised
centre.
- In order to avoid possible overheating, it is advisable not to use the product for more than 8
consecutive minutes.After use of 8 minutes, it is advisable to allow the appliance to cool down for
10 minutes and then it is possible to start using it again.
HOW TO SWITCH ON THE HAIR CLIPPER
Before plugging the device, ensure you the switch is in 0. Plug the appliance into a 230-240V socket.
Once the Hair Clipper has been switched on, it could result noisy and irregular .This is due to the
starting torque of the AC drive .This is not a manufacturing defect. Avoid using the product for more
than 8 consecutive minutes. For longer usages, it is necessary to allow the product to cool down
for 10minutes.Then it is possible to restart using it. After each usage, always turn the appliance off
and then unplug it.
CUTTING LENGHT ADJUSTMENT
The Hair Clipper Joycare is provided with an adjusting lever , necessary to adjust the cutting length
–also during its usage- from 2mm to 17mm.
4