Charging The Cordless Vacuum Cleaner; Battery Pack Replacement; Battery Disposal - Euroflex Cordless Monster 076 Manual De Instrucciones

CHARGING YOR CORDLESS VACUUM CLEANER
1. Plug the charging transformer into the wall outlet. Alternative way of charging: place the cordless
vacuum in the base, then plug the charging transformer into the wall outlet.
2. This vacuum cleaner is powered by NI-CD batteries. Before its first use, they must be charged for a
minimum of 16-20 hours.
3. Once the batteries are fully charged, the vacuum cleaner will run for approximately 15 minutes before
recharging is required.
4. To recharge, repeat step above described. Charging times will vary depending upon the amount of
usage between the charging cycles.
5. The charging indicator light (see fig. below) on the top of the vacuum will illuminate to indicate that
the vacuum is properly charging.
Note: peak performance may only be achieved after the until has been charged and discharged two or
three times.
Important: to maintain peak performance of your cordless hand vacuum, it is recommended that the unit
be fully discharged , then completely re-charged at least once a month.

BATTERY PACK REPLACEMENT

NOTE: if uncertain as to how to change your battery pack, we suggest you take your vacuum to a qualified
service centre to have this service performed.
The battery pack of your Monster 076 Cordless is replaceable, however care should be taken when doing
so. Follow these steps when replacement is required.
1. Open the battery compartment, by removing the screw located in the recess of the unit. Never open
battery compartment except to change the battery (if required).
2. Remove battery compartment cover. Set aside battery compartment cover with screw.
3. Carefully detach the two electrical connectors from the battery pack by pulling straight out from the
battery pack.
4. Lift out the old battery pack and set aside.
5. Insert the new battery pack in battery compartment and re-connect terminals by pushing lead wires
onto battery tabs.
6. Tuck wiring inside battery compartment so that the wiring does not interfere with the battery compart-
ment cover when it is re-positioned.
7. Re-install the battery compartment cover by sliding it over the battery towards the front of the unit,
making sure that the front snap engages the body of the unit.
8. Replace the battery compartment cover screw.
CAUTION:NEVER use the unit without the battery compartment cover in place.

BATTERY DISPOSAL

This vacuum cleaner contains nickel-cadmium(NI-CAD) batteries and must be disposed of properly. Call
your nearest recycling center for information on the recycling and disposal of nickel-cadmium(NI-CAD)
battery.
Fig. 1
17
Charging in-
dicator light
Fig. 2