Klutch NT1G Manual Del Operador página 10

INSTALLING GRINDING WHEEL
See Figure 2, page 14.
DANGER:
Use ONLY Type 27 depressed center wheels (such
as the one provided with this product). NEVER attach
a Type 1 straight or cut-off wheel to this grinder.
This product is only designed for grinding and
sanding. Use for any other purpose is not recommended
and creates a hazard, which will result in serious injury.
Type 27 − OK TO use
DANGER:
Never attach a wood cutting or carving blade of any type
to this grinder. It is only designed for grinding and sand-
ing. Use for any other purpose is not recommended and
creates a hazard, which will result in serious injury.
WARNING:
Thoroughly inspect a new grinding wheel before you
install it on the grinder.
• Tap lightly around the wheel using a wooden hammer.
• Listen carefully to the resulting sounds. Places with
fissures or cracks will result in a different sound.
Do not use a wheel containing fissures or cracks.
When you install a new grinding wheel, carry out a no
load revolution test of approximately one minute with
the grinding wheel facing a safe direction, i.e., away from
people or objects.
 Unplug the grinder.
 Depress and hold spindle lock button and rotate flange
nut with provided wrench until spindle locks.
ASSEMBLY
Type 1 − dO nOT use
10 - English
NOTE: To prevent damage to the spindle or spindle lock,
always allow motor to come to a complete stop before
engaging spindle lock.
 Loosen and remove flange nut from spindle. Do not
remove disc flange.
 Make sure flats on the bottom of disc flange are engaged
with flats on spindle.
 Place the grinding wheel over the spindle.
:
WARNING
Always install grinding wheel with the depressed center
against the disc flange. Failure to do so will cause the
grinding wheel to crack when tightening the flange nut.
This could result in serious personal injury because of
loose particles breaking off and being thrown from the
grinder. Do not overtighten.
 Thread the flange nut on the spindle with the flat side of
flange nut facing up. Fit raised, small diameter portion of
the flange nut into the hole in the wheel and finger tighten.
 Depress and hold the spindle lock button and rotate the
wheel clockwise until the spindle locks in position.
 Securely tighten the flange nut with the wrench provided.
Do not overtighten.
INSTALLING THE SIDE HANDLE
See Figure 3, page 14.
WARNING:
The side handle must always be used to help prevent
loss of control and possible serious injury.
 Unplug the grinder.
 Insert the side handle into the desired operating
position.
 Securely tighten by turning the side handle clockwise.
NOTE: The handle can be installed on the top, left, or right
side of the grinder, depending on operator preference.