Publicidad
Step 10
1
D14
Groove
å
Insert the DRAWER SIDES (D14 and D15) at an angle
into the slot at each end of the DRAWER FRONT (J2).
3
M67
Surface with
HIDDEN CAM
å
Fasten the DRAWER BRACE (M67) to the DRAWER
FRONT (J2). Tighten one HIDDEN CAM.
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
J2
D15
Maximum
Arrow
210 degrees
Minimum
190 degrees
J2
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
i s h
r f a
e d
c e
D14
J2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D985) into the
grooves in the DRAWER SIDES (D14 and D15) and
DRAWER FRONT (J2).
4
Start each screw a few turns before
BLACK 1-9/16" FLAT HEAD SCREW
D14
M67
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the DRAWER BACK (D61) to the DRAWER
SIDES (D14 and D15) and DRAWER BRACE (M67). Use
five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
409944
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D985
D15
completely tightening any of them.
30S
(5 used in this step)
D61
D15
Page 15
Publicidad
