Troubleshooting - Lanaform Samoa Manual De Instrucciones

TROUBLESHOOTING

In the event of a malfunction, under normal conditions of use, please refer to the following chart:
EN
Problem
No mist
Mist has an unusual smell
Low intensity
ADvICE REGARDING THE DISPOSAL OF WASTE:
• All the packaging is composed of materials that pose no hazard for the environment and which can be
disposed of at your local sorting centre to be used as secondary raw materials. The cardboard may be
disposed of in a paper recycling bin. The packaging film must be taken to your local sorting and recycling
centre.
• When you have finished using the device, please dispose of it in an environmentally friendly way and in
accordance with the law.
LIMITED WARRANTy
LANAFORM® guarantees this product against any material or manufacturing defect for a period of two years from the date
of purchase, except in the circumstances described below.
The LANAFORM® guarantee does not cover damage caused as a result of normal wear to this product. In addition, the
guarantee covering this LANAFORM® product does not cover damage caused by abusive or inappropriate or incorrect use,
accidents, the use of unauthorized accessories, changes made to the product or any other circumstance, of whatever sort,
that is outside LANAFORM®'s control.
LANAFORM® may not be held liable for any type of circumstantial, indirect or specific damage. All implicit guarantees
relating to the suitability of the product are limited to a period of two years from the initial date of purchase as long as a
copy of the proof of purchase can be supplied.
On receipt, LANAFORM® will repair or replace your appliance at its discretion and will return it to you. The guarantee
is only valid through LANAFORM®'s Service Centre®. Any attempt to maintain this product by a person other than
LANAFORM®'s Service Centre will render this guarantee void.
10
Possible causes
The water level in the reservoir is
too low.
The temperature of the unit is too
low.
The water has been standing in the
reservoir too long.
Too much/little water in the reservoir. Empty the water out of this reservoir
Sediment on the transducer(s).
The water is too cold.
The water is not clean.
Solution
Add water to the empty reservoir.
Place the unit in a room at ambient
temperature for half an hour prior
to use.
Clean the reservoir and pour fresh
water into it.
or add water to it.
Clean the transducer(s).
Use water that is at room
temperature.
Clean the reservoir(s) and pour fresh
water into it.