Troubleshooting - Lanaform Boreas Manual De Instrucciones

TROUBLESHOOTING

In the event of a malfunction, under normal conditions of use, please refer to the following chart:
Effects
Indicator red (no steam ), no indicator
light.
Mist has an unusual smell
Low intensity
ADVICE REGARDING THE DISPOSAL OF WASTE
• All the packaging is composed of materials that pose no hazard for the environment and which can be disposed of at
your local sorting centre to be used as secondary raw materials. The cardboard may be disposed of in a paper recycling
bin. The packaging film must be taken to your local sorting and recycling centre.
• When you have finished using the device, please dispose of it in an environmentally friendly way and in accordance with the
law.
LIMITED WARRANTY
LANAFORM® guarantees this product against any material or manufacturing defect for a period of two years from the date of
purchase, except in the circumstances described below.
The LANAFORM® guarantee does not cover damage caused as a result of normal wear to this product. In addition, the guarantee
covering this LANAFORM® product does not cover damage caused by abusive or inappropriate or incorrect use, accidents, the
use of unauthorized accessories, changes made to the product or any other circumstance, of whatever sort, that is outside
LANAFORM®'s control.
LANAFORM® may not be held liable for any type of circumstantial, indirect or specific damage.
All implicit guarantees relating to the suitability of the product are limited to a period of two years from the initial date of
purchase as long as a copy of the proof of purchase can be supplied.
On receipt, LANAFORM® will repair or replace your appliance at its discretion and will return it to you. The guarantee is only
valid through LANAFORM®'s Service Centre®. Any attempt to maintain this product by a person other than LANAFORM®'s Service
Centre will render this guarantee void.
Possible causes
If there is no indicator light.
The water level in the reservoir is too
low.
Water is leaking from the reservoir.
The temperature of the unit is too low.
The water has been standing in the
reservoir too long.
Too much/little water in the reservoir.
Sediment on the transducer.
The water is too cold.
The water is not clean.
Solutions
Check that the device is connected
and no breakdown has occurred in
that area.
Add water to the reservoir.
Check that the reservoir is in the right
position.
Place the unit in a room at ambient
temperature for half an hour prior to
use.
Clean the reservoir, then pour into it
clean, fresh, distilled or demineralised
water.
Empty the water out of the reservoir or
add water to it.
Clean the transducer.
Use water that is at room temperature.
Clean the reservoir, then pour into it
clean, fresh, distilled or demineralised
water.
Boreas
EN
7