Publicidad
Idiomas disponibles
Idiomas disponibles
When in function, make sure that the pump surface is not blocked.
•
When in function, make sure that the pump does not take in sand, as this could seriously damage the unit and void the guarantee (read carefully the maintenance paragraph).
•
Due to the high attraction level between the magnets in the support, keep out of reach of children.
•
Avoid attaching the magnets directly to one-another.
•
Make sure you hold the magnets from the sides and avoid placing hands, fingers in between.
•
At a distance up to 5 cm (1,97 inches) the magnets attracts metal objects and other magnets with a high force: to prevent injuries, avoid closeness with blades, sharp objects or other magnets.
•
The magnet can cause permanent damage to electrical devices or articles that are affected by a magnetic field such as pacemakers, credit cards, or keys: always maintain them at a minimum
•
distance of 30 cm (12 inches).
When not in use, always place the carton separator between magnets.
•
If exposed to temperature higher than 50° C (122° F) the magnets can lose part or all the attracting power.
•
Always clean the aquarium side before placing the suctions cup+ magnet support: any dirt on the surface might prevent the suction cup from attaching properly and the pump might slip on the
•
bottom of the aquarium causing damage to things and itself.
Please keep these instruction in a safe and dry place.
•
Installation
Attention: please verify that all components of the pump are undamaged before putting it into function. Before any kind of intervention, ALWAYS disconnect electrical supply of the pump and
any other appliance placed in the water. Be sure that the voltage of the mains supply corresponds to the voltage shown on the unit' s label. In order to prevent noise and disturbance caused by
vibration we suggest to position the pump avoiding lateral contact with the aquarium glass or in an upward position on the bottom.
Unwind the electric cable.
•
Insert the rotation sphere of the base in the proper slot on the suction cup-magnet support. - Fig. 2/2a -
•
Immerse the pump completely and turn it in a vertical position in order to allow any air to come out of the impeller chamber.
•
Attach the pump with the internal part of the suction cup + magnet support to the aquarium side as desired - Fig. 3/3a - (remember to clean the surface before attaching the support).
•
Holding with one hand the pump attached inside the aquarium, place the external part of the magnetic support on the outside of the aquarium at a distance of approx. 10 cm (3.93 inches)
•
from the centre of the internal support. Slowly move the external support until you feel the attraction between the magnets and place them so that the centres are on the same axis. - Fig. 4/4a -
Direct the water flow as desired.
•
Connect to electrical supply.
•
Regulation
The flow is regulated through the control knob, built in the rotor chamber, where the water suction is also located. -fig. 6-.
10
English
Publicidad
