RIB KING Manual Del Usuario página 5

1st Connection of the receiver (performed at the factory)
2nd Mounting, power supply, alignment and memorization of the
NOVA Wi-Fi photocells
Attach the photocells to the poles or to posts.
Place micro-switch 1 set to ON (the other micro-switches must be set to
OFF) on both the receiver and the transmitter.
Insert the AA batteries (cod. ACG9519) in the chamber checking their
polarity.
Transmitter TX => The green LED of the transmitter comes on for 10
seconds indicating that it is working correctly, it then
turns off but the transmitter remains active.
Receiver RX => The red LED comes on for 3 seconds, if it turns off after
3 seconds, position the optical groups until the red LED
emits a constant light. Three minutes after inserting the
batteries the red LED turns off, for another 3 minutes
push S3 PROG TX
Use the following procedure for memorization:
1. Set DIP 1 of the SW1 on the MASTER Wi-Fi to ON
2. Push the PROG RX button on the MASTER Wi-Fi => dual-colored
EDGE PHOT 1 LED flashes red for 1 minute (the time necessary for
memorization).
3. Push the S3 PROG TX button on the photocell receiver => on the
MASTER Wi-Fi the dual-colored EDGE PHOT 1 LED changes from
flashing red to green and a sound from the buzzer indicates that
the photocell has been memorized correctly, immediately the dual-
colored EDGE PHOT 2 LED begins flashing red.
4. After one minute the dual-colored EDGE PHOT 2 LED turns off or, push
the PROG. RX button 4 times to exit the memorization procedure =>
all dual-colored EDGE PHOT LEDs should be off.
3rd Supplying power to the SPARK Wi-Fi blinker
Insert the three C batteries (cod.ACG9518) provided into the chamber
checking their polarity
Do not mount the orange diffuser so as to be able to perform the
memorization of the MASTER Wi-Fi card (point 7)
SIMPLIFIED INSTRUCTIONS FOR KING WITH T2 Wi-Fi
GREEN => PED
GREY => COM
YELLOW => EDGE
BLACK => PHOT
WHITE => CONTROL BUTTON
BROWN => A+ TEST
CONTROL BUTTON
MOTOR 2
MOTOR THAT CLOSES FIRST
CONNECT CAPACITOR BETWEEN V2 and W2
U2 => 3
V2 => 1
W2 => 2
MOTOR 1
MOTOR THAT OPENS FIRST
CONNECT CAPACITOR BETWEEN V1 and W1
U1 => 3
V1 => 1
W1 => 2
ELECTRICAL SUPPLY
230V 50-60Hz