Descargar Imprimir esta página

Sauder Summit Station 425014 Folleto De Instrucciones página 11

Publicidad

Step 6
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten one EXTENSION RAIL (35MA) to the RIGHT END (A). Use two GOLD 5/16" FLAT HEAD SCREWS (3S)
å
through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the
å
inner cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWER.
å
Push the black lever in and pull the SLIDE from the RAIL.
The CAM SCREWS
must be here.
www.sauder.com/service
35MC
425014
35MA
GOLD 5/16" FLAT HEAD SCREW
(2 used for the RAIL)
1
2
3
A
3S
Open end
Page 11

Publicidad

loading