Mellerware Procare 2300 Manual Del Usuario página 7

g Flannel
h Cotton
i Mode selector button
j On/off button
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
INSTALLATION
- Make sure that all products' packaging has
been removed.
- Extend the telescopic poles to desired height
and lock in place (Fig.1).
- Insert the thick side of the telescopic poles into
the main body and lock in place (Important: the
power cord hook must face backwards) (Fig.2).
- Insert the collar hanger into the top of the iron-
ing board (Fig.3).
- Press the button on the back of the ironing
board to change the position into vertical/hori-
zontal (Fig.4).
- Open the lock of the ironing board, install the
board along the telescopic poles, and lock in
place (Fig.5).
- Hang the steam nozzle on the collar hanger (D)
or in the side support accessory (H).
INSTRUCTIONS FOR USE
BEFORE USE:
- Some parts of the appliance have been lightly
greased. Consequently, the first time the ap-
pliance is used a light smoke may be detected.
After a short time, this smoke will disappear.
- To eliminate the smell given off by the appli-
ance when used for the first time, it is recom-
mended to have it on at full power for 2 hours in
a well-ventilated room.
FILLING WITH WATER:
- You must fill the water compartment before
turning on the appliance.
- Remove the appliance's water tank (I).
- Open the water inlet lid.
- Fill the compartment with cold water.
- Fill the water tank taking care to observe the
MAX level.
- Close water inlet lid.
- Put the deposit back into its housing, ensuring
that it is inserted properly.
USE:
- Extend the cable completely before plugging
it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off
button (j).
- Wait for the pre-heating light (b) to stop flashing
and remain fixed, which will indicate that the
device has reached the proper temperature.
- Wait approximately 48 seconds and steam will
start to flow out. Place the iron button in the
steam position (upwards).
- The steam position down means the iron works
into normal mode (without steam).
SLEEP MODE:
- In dry ironing or wet steaming state, machine
will enter to the sleep mode after 15 minutes
without any electronic device operation.
- The device resuming work will be done within
3 minutes and it will take around 25 seconds to
pre-heat.
LACKING WATER INDICATOR:
- The machine will start its automatic protection
function and stop working when the water tank
is not placed on the main body or if there is a
lack of water.
- The water indicator light will start flashing until
the water tank filled is placed in the main body.
SENSITIVE FABRIC PROTECTION:
- To prevent the fabric from being damaged by
high temperatures, please use the sensitive
fabric protection (Fig.7).
- Do not install or dismantle the sensitive fabric
protection while it is hot or in use.
STEAM GARMENT:
- The steam garment is easy to use and is
perfect for removing wrinkles/creases from
garments and curtains as well as refreshing
furnishings fabrics.
- It can be used on most fabric as long as the
fabric is hanging or where the garment steamer
can be easily used in an upright position mov-
ing over the fabric in an up and down motion.
- NOTE: the garment steamer is designed to be
used in an upright position on hanging gar-