Troubleshooting - Pur Line DRYOS HEPA Manual Del Usuario

TROUBLE SHOOTING
If there is something wrong during operation, it may not be the unit's problem. You may check against the following
list before send for repair:
Problem
The unit is not
working
Poor performance
Leakage
Abnormal noise
Notice:
· If the problem cannot be found in the list or it persists, please contact our service center or a qualified technician for
further inspection.
· Do NOT open and repair the unit by yourself. Use only qualified agents for repairs or services.
WARRANTY
All the warranty terms finish 24 months after the buying date. It is absolutely necessary to show your buying invoice to be
covered by the warranty terms. The warranty covers any defect produced during the manufacturing or caused by the raw
material used in this product, and only in the event that the customer has followed the instructions and maintenance showed
in the user's manual, and only in the event that the installer has followed the installation directions. This warranty does not
cover any damage caused by accidents or negligence. The warranty only covers the customer in case that any reparation
has been done in our authorised repairing shops. The warranty DOES NOT COVER any damage or injury caused to people,
animals or things caused by an accident or the negligent use of this product. The warranty will be suspended in case of any
manipulation of unauthorised people or in case of non-original parts or components.
DISCARDING WORN HOUSEHOLD DEVICES
The European directive 2012/19/EC pertaining to electrical and electronic waste prohibits such household goods
from being discarded with local refuse services. Worn devices must be collected separately to optimize the recovery
and recycling rates of the components therein to reduce detrimental effects on the environment and on human
health.
This unit may be submitted to changes in specifications, characteristics and/or operation without prior notice to the user, in order to continue
improving and developing its technology
EN
Possible reasons
Power cord is not plugged/
power has no electricity
Power switch is off
End of service life
Air inlet/outlet is blocked
Wrong installation of the
filter direction
The filter is too dirty
Indoor temperature or humidity is too low
Please make sure all the package is removed
Full water tank
Floater is fallen off in water
tank
Please make sure all the package is removed and check any damage on
the appearance.
Please make sure the air inlet and outlet is not blocked by other stuff, and
clean it if necessary
12
Solutions
Plug in the power supply/ Ensure the power
supply is working
Press "on/off" button
Change the filter
Clean foreign parts of air inlet/outlet
Install filter in the right way
Clean or change the filter
Discharge water from tank
Check that the water tank float is in place