Tabla de contenido
Publicidad
CONTROL PANEL
CONTROL PANEL
TNP-1201,1501,2151
TNP-1201,1501,2151
All Full Range models in the Tessen Passive range utilise the same intuitive input panel. The TNP-1800S
Subwoofer is described on page 10.
1: INPUT: A standard 'Speakon' compatible NL4 input connector which serves the cabinet in passive or
bi-amp mode.
2: LINK: Connected in parallel with the Input connector allowing for additional cabinets to be added to
the speaker chain.
Please consider the drive capabilities of your amplifier (consult manufacturers technical information) and
speaker input impedances (detailed on the Tessen panel) when connecting cabinets using the link feature.
3: OPERATING MODE:
BI-AMP
Allows the woofer and tweeter to be directly driven from separate amplifier channels
± 1 LF 8Ω
either using a 4 core cable or two differently wired cables. A system controller must be
± 2 HF 8Ω
used as there is no x-over or protection for the drivers.
The Tessen passive cabinets are shipped in 'Full Range' mode which is indicated on the
FULL RANGE
panel. They are user configurable and will operate in either full range or Bi-Amp mode if
± 1 IN 8Ω
required. A single full range amplifier channel drives both woofer and tweeter via the
± 2 N/A
internal xover.
CONNECTION DIAGRAM:
FULL RANGE MODE
ONLY
1+,1- ARE USED
BIAMP MODE
HF CONNECTED TO 2+,2-
LF CONNECTED TO 1+,1-
INPUT
INPUT
1 1
BI-AMP
BI-AMP
± 1 LF 8Ω
± 1 LF 8Ω
3
3
± 2 HF 8Ω
± 2 HF 8Ω
FULL RANGE
FULL RANGE
± 1 IN 8Ω
± 1 IN 8Ω
± 2 N/A
± 2 N/A
1+
1+
1+
1+
1- 1- 1-
1- 1- 1-
2+
2+
2+
2+
2- 2- 2-
2- 2- 2-
1+
1+
1+
1+
1- 1- 1-
1- 1- 1-
2+
2+
2+
2+
2- 2- 2-
2- 2- 2-
1+
1+
1- 1- 1-
2+
2+
2- 2- 2-
1+
1+
1- 1- 1-
2+
2+
2- 2- 2-
WWW.HHELECTRONICS.COM
LINK
LINK
REMOVE SPEAKER PANEL TO
REMOVE SPEAKER PANEL TO
CHANGE BETWEEN FULL
CHANGE BETWEEN FULL
RANGE & BI-AMP MODES
RANGE & BI-AMP MODES
+
+
HIGH-PASS
HF
_
_
+
+
LOW-PASS
LF
_
_
+
+
HF
_
_
+
+
LF
_
_
2 2
NL4 WIRING:
7
5
Publicidad
Tabla de contenido
