Makita XRT01 Manual De Instrucciones página 17

7. After assembling, confirm that the contact plate
can move as shown in the figure.
► 1 . Contact plate
Error display and error tone
CAUTION:
During inspection, be sure to lock the trigger, turn the power off, and remove the battery
cartridge. Failure to do so may cause an accident.
CAUTION:
When you turn the power on, never bring your limbs or face close to the binding or rotating
parts of the tool tip. Otherwise, you may be injured.
CAUTION:
When the power is turned on, never touch the binding or rotating parts of the tool tip.
Otherwise, you may be injured.
CAUTION:
If an error tone sounds, or if the tool malfunctions, immediately stop using the tool.
Error tone and display
If an error occurs, an error tone will sound, and an error number will be shown on the display panel. Refer to the
following table and take appropriate actions. If the error persists, ask Makita Authorized Service Centers for repairs.
Display
1
2
3
4
5
6
7
1
Symptom
The tool stops operating.
The tool stops operating.
The tool does not perform the tying
process in continuous actuation mode.
The tool does not start.
The tool stops operating.
The tool stops operating.
The tool stops operating.
The tool does not start.
The tool stops operating.
NOTE: If the contact plate is caught, press it as
shown in the figure.
Possible cause
The wire has been used up.
Tie wire is not loaded.
Wire feeding has failed.
The curl guide is open.
The contact plate is caught.
The battery has been
discharged.
The temperature of the battery
cartridge is abnormally high.
The motor is overloaded.
Motor failure
The temperature of the tool is
abnormally high.
Tool failure
17 ENGLISH
Solution
Load new tie wire.
Load tie wire.
Check the orientation of the tie wire.
Unload the tie wire, and load it again.
Clean the path of wire.
Close the curl guide.
Release the contact plate from
being caught.
Recharge the battery.
Cool the battery cartridge down.
Replace the battery cartridge
with a recharged one.
Determine the cause of the
obstruction of the motor rotation
and solve the problem.
Cool the tool down.
Ask Makita Authorized Service
Centers for repairs.