Makita XRT01 Manual De Instrucciones página 9

2. Peel off the tape that holds the wire, and pull the
tip of the wire out.
2
1
► 1 . Tape 2. Tip of wire
3. Open the reel cover.
► 1 . Reel cover
4. Mount the wire reel on the tool in the orientation
shown in the figure.
► 1 . Wire reel
NOTICE:
Be sure to mount the wire reel in the
orientation shown in the figure. If it is mounted the
other way around, the wire will be released and may
be twisted.
1
1
9 ENGLISH
5. Make the tip of the wire straight, and pass the wire
through the guide.
► 1 . Guide
NOTE: If the tip of the wire is bent when it is passed
through the guide, the wire may become jammed in
the tool.
NOTE: If you force the wire when trying to pass it
through the guide, the wire may become jammed.
6. Pull the wire out approximately 10 mm (1/2") from
the tip of the arm.
► 1 . Arm 2. Approximately 10 mm (1/2")
NOTICE:
If the length of the pulled-out wire is
insufficient, the wire may be broken off when tied,
or tying strength may be compromised due to
insufficient wraps.
1
2
1