Sensor Functionalities And Adjustments; Light Sensor; Wind Sensor; Temperature Sensor - Allmatic KAIROS Manual De Instrucciones

5. SENSOR FUNCTIONALITIES AND ADJUSTMENTS

In this section it is necessary to operate simultaneously with the instructions of the sensor and the control unit in use.
Functionalities are related to the sensor model in use (see Table 2 in Chapter 3.1).
5.1 LEARNING OF THE SENSOR
Each sensor can be learned on one or more control units (positioned within a maximum range of 20-25 meters).
To learn the sensor on the control unit refer to the instructions of the control unit in use.
A short press of the button A (< 2 sec.) carries out the transmission by the sensor, displayed with a fast flashing red color of the
multicolored LED F .
5.2 DESCRIPTION OF THE REGULATION TRIMMERS
Each KAIROS has two trimmers placed on the back of the same, thanks to which you can adjust the sensor associated with it.

LIGHT SENSOR

The adjustment ranges from a few lux up to a maximum of 60Klux.
By setting a low value the sensor will react with little brightness.
WARNING! The sensor reacts after the brightness has remained stable above or below
the threshold for at least 10 minutes. This is to avoid continuous movements by the
automation.

WIND SENSOR

The adjustment ranges from a few km/h up to a maximum of 80km/h (160km/h for KAIROS
PERGOLA). By setting a low value the sensor reacts with little wind.
You can disable the wind sensor by turning the trimmer completely clockwise.
WARNING! Disabling the wind sensor there is a risk of damaging the automation.
RAIN SENSOR
The adjustment ranges from little moisture detected to heavy rain detected on the sensor.
By setting a low rain value the sensor will react with little water/humidity, while setting a high
value the sensor will react in the presence of a lot of water.
WARNING! The sensor is also sensitive to moisture in the hands. For this reason,
when adjusting, be careful NOT TO TOUCH the sensor with your hands.

TEMPERATURE SENSOR

The temperature thresholds are defined and cannot be changed.
The sensor will intervene when the surrounding temperature has fallen below the threshold of
about 4 º C ( in "SA" versions the threshold is around 2 º C).
POSITION "Test"
Each trimmer also has a position called "Test".
This position is found by turning the trimmer completely counterclockwise.
In this position the sensor speeds up the threshold transitions and the sending of alarms and has a very high sensitivity to the
atmospheric event.
For this reason, in some environments, the "Test" position could make the sensor always look alarmed.
6-1622652 - rev.4 - 20/05/2021 ENG
Test
40
20 60
Test km/h
Test
Rain
7 / 12