Allmatic KAIROS Manual De Instrucciones página 20

5.3 ADJUSTMENT OF THE SENSOR
The sensor has a ADJUSTMENT MODE to be able to correctly adjust the sensors according to your needs and the environmental
conditions in which you are located.
Entering the ADJUSTMENT MODE you can view the current status of the sensors and, by adjusting the intervention thresholds, find
the desired value of brightness, wind speed and amount of rain needed to intervene the sensor.
To enter the ADJUSTMENT MODE you need to press and hold the button A on the sensor for 10 seconds, until the LED turns green.
In this condition the status of the light sensor is displayed.
With another short press of the button the LED becomes yellow and displays the status of the wind sensor.
With another short press of the button the LED becomes red and displays the status of the rain sensor.
With another short press of the button the LED becomes green and displays the status of the temperature sensor.
To exit the ADJUSTMENT MODE, briefly press the sensor button A or wait 5 minutes.
In this mode, by moving the trimmers, it is possible to identify the transition thresholds between fixed LED and flashing LED, corre-
sponding to the ambient conditions detected by the sensor at that time.
TABLE 3 - Use of ADJUSTMENT MODE.
Sensor LED Colour
Light
Wind YELLOW
Rain
Temperature
WARNING!
When using this mode, the sensor does not communicate to the associated control unit the situation detected by the
sensors.
The intervention of the sensor in the detection of the atmospheric event is not immediate and is related to timing to avoid false
alarms or accidental interventions. During the adjustment mode such times are reduced to allow a smoother configuration.
Please refer to the table below for values against each sensor.
TABLE 4 - Thresholds and response times of the sensors.
SENSOR SETTING
THRESHOLD
ADJUSTMENT
NORMAL
Minimum time
above threshold
Minimum time
below threshold
THRESHOLD
ADJUSTMENT
ADJUSTMENT
MODE Minimum time
above threshold
Minimum time
below threshold
8 / 12
FIXED LED
(sensor does not intervene)
GREEN Below the set threshold
Below the set threshold
RED Below the set threshold
GREEN > 4°C ( > 2°C "SA" version)
LIGHT
SENSOR
• PERGOLA vers.: Trimmer
Trimmer
little moisture - heavy rain
min: 100 lux
• Standard vers.: 23% umidity
max: 60 Klux
• "SA" vers.: 20% umidity
10 min 4 sec.
10 min 60 sec.
• PERGOLA vers.: Trimmer
Trimmer
little moisture - heavy rain
min: 100 lux
• Standard vers.: 23% umidity
max: 60 Klux
• "SA" vers.: 20% umidity
4 sec. 4 sec.
4 sec. 4 sec.
FLASHING LED
(sensor intervention)
Above the set threshold
Above the set threshold
Above the set threshold
< 4°C ( < 2°C "SA" version)
RAIN
SENSOR SENSOR
Trimmer
• PERGOLA vers.:
0-160Km/h
• OTHER: 0-80 Km/h
4 sec.
60 sec.
Trimmer
• PERGOLA vers.:
0-160Km/h
• OTHER: 0-80 Km/h
2 sec.
2 sec.
ENG
LED FLASHES
SLOW
-
Sensor disabled
-
-
WIND TEMPERATURE
SENSOR
• Standard vers.:
around 4°C
• "SA" vers.: around 2°C
30 sec.
30 sec.
• Standard vers.:
around 4°C
• "SA" vers.: around 2°C
5 sec.
5 sec.
6-1622652 - rev.4 - 20/05/2021