Kohler VINTAGE K-2800 Instrucciones De Instalación página 3

S
Drill a 1/4" (6mm) mounting hole
at the mark on the floor, then
drill two 1/4" (6mm) bolt holes at
the marks on the wall.
S
Mount bolts to the wall so
approximately 3/4" (2cm) of
each bolt remains exposed.
NOTE: Other fastening devices of
sufficient size and strength may also
be used.
S
Install the faucet and drain to the
lavatory according to the
manufacturer's instructions.
NOTE: Do not fully tighten slip-joint
drain connections at this time.
S
Position the pedestal mounting
hole over the hole in the floor.
S
Secure the pedestal to the floor
with lag bolt making sure
mounting bar is resting across
the lugs in the base of the
pedestal.
CAUTION: Risk of product
damage. Do not overtighten lag
bolt. Overtightening may cause
damage to the product.
S
Set the lavatory on the pedestal
so the bolts extend through the
lavatory holes.
S
Level the lavatory.
S
Install the cap nuts and washers,
and tighten until snug.
CAUTION: Risk of product
damage. Do not overtighten cap
nuts. Overtightening may cause
damage to the product.
S
Connect and tighten the trap to
drain. Connect the hot and cold
water supplies to the faucet.
Kohler Co., Kohler, WI U.S.A.
Bolts
Finished Wall
Pedestal
Base Lugs
Finish Wall
Hanger
Bolts
Pedestal
Washer
1010423-2-
3
Lag Bolt
Pedestal
Mounting Bar
Lavatory
Cap Nut
A