Power Source; Remote Battery Installation - memorex Mini Soundbar Guia Del Usuario

AC CONNECTION
Insert the small end of the AC adapter
into the DC IN 5V jack (located on the
rear of the unit). Connect the other end
to a wall outlet having 120V AC, 60 Hz.
AC Adapter, DC 5V Z
NOTES:
• Remove both the DC plug and the AC IN plug to disconnect the AC
adapter when not in use.
• Use only the supplied AC adapter which has the following specs:
DC 5V Z

REMOTE BATTERY INSTALLATION

Follow these precautions when using batteries in this device:
1. Caution – Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated
in the Battery Compartment. A reversed battery may cause damage to
the device.
4. If the device is not to be used for a long period of time, remove the batteries to
prevent damage or injury from possible battery leakage.
5. Do not try to recharge a battery not intended to be recharged; it can overheat
and rupture. (Follow battery manufacturer's directions.)
6. Remove batteries promptly if consumed.
7. Clean the battery contacts and also those of the device prior to battery
installation.

POWER SOURCE

1. Remove the Battery Compartment by
pressing in on the tab and then sliding
the compartment out.
2. Install a CR2025 battery, paying
attention to the polarity diagram in the
compartment (positive side up).
3. Replace the Battery Compartment.
BATTERY PRECAUTIONS
6
To DC IN Jack