jcm-tech MINIMAN+DCS Manual De Instrucciones página 16

Finally, insert the transmitter and press any channel. A short
beep and the momentary appearance of the confirmation screen
will indicate that the operation has been carried out correctly.
Once finished, you will return to the previous screen. In this
way, the same pin already entered can be used with as many
transmitters as you wish.
4.6 FUNCTION RECORD FACILITY "PIN" AND INSTALLER CODE IN A
TRANSMITTER.
Press the key and
Then, key the four figures corresponding to the PIN of the
installation. As you press the numerical keys, the display will
visualise the numbers. For example, if the PIN is "1234", it
will show:
Once the code has been keyed, press
will tell you to insert the transmitter:
Finally, insert the transmitter and press any channel. A short
beep and the momentary appearance of the confirmation screen
will indicate that the operation has been carried out correctly.
Once finished, you will return to the previous screen. In this
way, the same pin already entered can be used with as many
transmitters as you wish.
Thank to this function, the facility "PIN" and the installer code will both be recorded
4.7 COPY MEMORY CARD FUNCTION
Press the key and the following screen will appear:
Then, insert the receiver memory card in the corresponding
connector and press the key
as before will indicate that the contents are being copied to the new memory card.
Once the operation has finished, the portable programmer will return to the first screen
and will be ready to repeat the operation (the origin card will have to be reinserted if you
want to copy another memory card).
and the following screen will appear:
and another screen
following screen will show you that the
programme is reading the content of
the card.
Once all of the contents have been
copied, the screen will appear to
show that you can remove the card
you wanted to copy and fit the destination card. The same screen
16
. The