Servicing - Cub Cadet L20 Manual Del Usuario

EN
Working with the trimmer
Hold the rotating line roughly parallel to
the ground (not inclined by more than
30°). This trimmer is not an edge trimmer.
Do not incline the trimmer so that the line
rotates at a right angle to the ground. The
resulting flying debris could cause severe
injuries!
With the trimmer switched on, hold it at an appro-
Î
priate angle and move it from side to side I J .
Maintain a minimum distance 610 mm between
Î
your feet and the protective cover K .
Practical trimming tips J K
Cut using the tip of the cutting line. Do not use
Î
excessive force when moving the cutting head
through uncut grass.
Note
Wire and picket fences result in increased
line wear and even in breaking of the line.
The line may wear quickly on stone and brick
walls, kerbstones and wooden surfaces.
Do not move the line head over the surface of the
Î
ground or other surfaces.
If cutting long grass, cut from the top to the bottom
Î
and when doing cutting do not exceed a height of
30 cm.
Hold the trimmer so that it is inclined towards the
Î
area to be cut.
When cutting, rotate the trimmer from left to right.
Î
This prevents cuttings hitting the operator.
Avoid trimming trees and bushes, bark, wooden
Î
slats, wall cladding and fence posts. The line could
quickly and easily damage them.
Removing the power pack G
Press the power pack release [A] 1 .
Î
Remove the power pack [B] 3 .
Î
24
WARNING!

Servicing

Risk of injuries or material damage due to
moving parts.
¾ Only clean or service the device if the
motor is stationary and also the cutting
tool.
¾ Always remove the power pack prior to
working on the device.
¾ Do not clean the device with water.
¾ Repair and service work as well as the
replacement of safety elements must
be performed by a qualified expert or
workshop.
Cleaning
Switch the trimmer off and wait until the cutting tool
Î
comes to a standstill and remove the power pack.
Clean the device with a hand brush after every
Î
use.
Clean the ventilation slots and underside of the de-
Î
vice at regular intervals to remove grass residues.
Fitting and replacement of the trimming
line LMN
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating
line.
¾ Always remove the power pack prior to
working on the device.
¾ Never use metal-reinforced cord, wire,
chain, rope or similar. This could break
off and form dangerous projectiles and
severely damage the device.
¾ Use only original replacement line with
a diameter of 2.0 mm. Use of a thicker
trimming line can cause the motor to
overheat or fail.
Cut the new trimming line to a length of no more
Î
than 6 m.
Rotate the line head [B] anticlockwise until the
Î
arrow [A] on the line head is aligned with the line
eye [C] in the spool housing L 1 .
WARNING!
WARNING!
Servicing