Intended Use; Operating Instructions; Assembly And Operation; Function Selection - Worx Nitro WX031L Manual De Instrucciones

4. INTENDED USE

This machine can be used as both vacuum cleaner and
blower. With the strong suction power, it can pick up
wet and dry messes easily.

5. OPERATING INSTRUCTIONS

NOTE: Please read the instructions carefully
before use.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Take out all accessories
Unhook the tank latches on each side
to open the lid and take out all the
accessories.
Hose hook assembly
Install the hose hook onto the lid, facing
it upward.
Assembling the shoulder strap

Function selection

12
This machine has the suction inlet
(Position 1) and blower outlet (Position
2) separately. Connect the hose to the
proper port depending on your work.
Function as a vacuum
Insert the hose into the suction inlet
(Position 1).
Nozzle assembly
When using as a vacuum, you can
choose wide nozzle and crevice nozzle
depending on different working needs.
Function as a blower
Insert the hose into the blower outlet
(Position 2).
Checking the battery charge condition
NOTE: Fig. F1 only applies for the bat-
tery pack with battery indicator light.
Charging the battery pack
Installing the battery pack
OPERATION
20V Cordless Wet/Dry Vacuum Cleaner EN
Turning on the machine
Press the on-off switch to start operation.
Power Selection
When the switch is pressed for the first
time, the machine starts and works at
high speed. Press the ECO button for a
low speed. Press it again, the cleaner will
switch to high speed. To stop, press the
ON/OFF switch again.
NOTE: When working under high speed,
the light is not on. When working under
ECO mode, the light shows green.
WARNING: Please keep the air
FIGURE
intake unobstructed, otherwise it
may cause motor overheating and may
damage the machine.
Using as a vacuum cleaner
See Fig.
A1, A2
Dry Vacuuming
Vacuum items only small enough to
fit through the hose. When vacuuming,
make sure that the filter stays in place.
See Fig. B
The performance of the vacuum will
decrease with a full collection container.
When emptying the collection container,
See Fig. C
check to see if the filter needs cleaning.
Attention:
1. Do not suck sharp objects such as nails
into the vacuum.
2. Do not suck objects with high
temperature such as carbon ash. Please
let it cool down first.
3. Clean the HEPA filter regularly.
Wet Vacuuming
See Fig.
This machine is equipped with double-
D1, D2 probe detector, which is designed to
shut off the suction when the collection
container reaches full wet capacity. When
the collection container is full, empty
the collection container as shown in
Maintenance.
See Fig. E
Attention:
1. Put the machine on the flat ground.
2. Make sure the filter is completely dry
after picking up water or wet dust.
See Fig. F1
Using as a blower
Open the rubber cover on position 2
See Fig.F2
to start using the air blowing function
and put it back to its original place after
See Fig.F3
completion.
WARNING: Never point the nozzle
at anyone in the vicinity.
See Fig.
G1, G2
See Fig.
H1, H2
See Fig. I