Bimar HFP10 Folleto De Instrucciones página 22

Operation by remote control
NOTE: The heater must be turned on using the O / I switch before it can be operated via the
remote control.
• The remote control requires 2 "AAA"/(LR03. 1,5V) batteries (not included).
• Open the battery compartment by sliding the cover down and insert the batteries
observing the polarity indicated in the battery compartment.
• Keep the batteries out of the reach of children.
• The operations of the remote control are the same as the functions of the control panel.
• The remote control must be pointed frontally (maximum distance of about 4m) towards
the display (top right).
We recommend replacing all batteries at the same time. Do not mix old and new batteries.
For long periods of inactivity of the remote control remove the batteries.
Remote control "DRIMMER" button (8): when pressed it adjusts the brightness of the flame
(intensity: 1-5), and the selected status appears on the display (D).
Day / hour / minute setting
Synchronize the clock of the device with the local time, proceeding as follows:
• Press the DAY/TIME button "14", and when the day flashes press the button "2" ▲ or " 5" ▼
to select the day.
• Press the DAY/TIME button again, then press the
• Press the DAY/TIME button again, then press the + OR - button to set the minutes.
• Press the OK button to confirm the setting.
Power Off (OFF)
Device on (ON), and in stand-by Mode
-
Press to activate / deactivate the flame
effect
-
Press and hold to toggle among 5
different flame level levels
Press to activate 1000W heating;
1000W
will appear on the display
Press to activate 2000W
2000W
22/64
heating, the symbols
will appear on the display
"4" o "13" to set the time.
the symbol