Panasonic S-224ME2E5 Manual Del Usuario página 27

9-2-2. Setting Changes by the High-spec Wired
Remote Colltroller (CZ-RTC3)
1. Keep pressing the
buttons simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
LCD display.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4.Test run
Sel. Page [
2. Press the or
menu.
If you wish to see the next screen instantly, press
the or button.
Select "8. Detailed settings" on the LCD display
and press the button.
Maintenance func
5. Sensor info.
6. Servicing check
7. Simple settings
8. Detailed settings
Sel. Page [
The "Detailed settings" screen appears on the LCD
display.
Select the "Unit no." by pressing the
button for changes.
Detailed settings
Unit no. Code no.
3-1
Sel. Next
3. Select the "Code no." by pressing the
button.
Change the "10" by pressing the
button (or keeping it pressed).
( "0006" set at shipment
Detailed settings
Unit no. Code no.
3-1
Sel. Next
, and
20:30 (THU)
] Confirm
button to see each
20:30 (THU)
] Confirm
or
20:30 (THU)
Set data
10 0006
or
or
)
20:30 (THU)
Set data
10 0006
4. Select the "Set data" by pressing the
button.
Select the "0017" by pressing the
button.
Then press the
Detailed settings
Unit no.
3-1
[
Sel.
5. Select the "Code no." by pressing the
button.
Change the "1D" by pressing the
button (or keeping it pressed).
( "0000" set at shipment
Detailed settings
Unit no.
3-1
Sel.
6. Select the "Set data" by pressing the
button.
Select the "0023" by pressing the
button. Then press the
Detailed settings
Unit no.
3-1
Sel. [
N OTE
Discharge temperature may decrease and become
shortage of capacity if the value set at shipment
remains.
Item code
Heating
discharge
1D
temperature
shift
7. Select the "Unit no." by pressing the
button and press the
The "Exit detailed settings and restart?" (Detailed
setting-end) screen appears on the LCD display.
Select "YES" and press the
Detailed settings
Exit detailed settings
Unit no.
1-1
Sel.
N OTE
When returning to the duct setting, set the "10 " item
code to the set data "0006", and the "1D" to the set
data "0000".
27
or
button.
20:30 (THU)
Code no. Set data
10 0017
] Confirm
or
)
20:30 (THU)
Code no. Set data
1D 0000
Next
or
button.
20:30 (THU)
Code no. Set data
10 0023
] Confirm
Setting data Set value of
heating discharge
No.
temperature
0023 45ºC
button.
button.
20:30 (THU)
Code no. Set data
and restart?
10 0001
YES NO
Next
or
or
or
or