Matco Tools MNTS13 Instrucciones De Ajuste página 2

WARNING
Always wear ANSI approved safety goggles when using this
product (Users and Bystanders). Failure to read and follow all
warnings and operating instructions may result in damages
and serious injuries or death.
OPERATING INSTRUCTIONS
1. Choose the rivet nut size to be installed.
2. Install the correct size mandrel/nosepiece for the rivet nut to be
installed. See photos and instructions for changing the
mandrel/nosepiece and adjustment.
3. Drill a hole in the work product the same size or slightly larger
than the outside diameter of the rivet nut to be installed.
4. To install the rivet nut, open the handles outward as far as
possible and thread the rivet nut clockwise onto the mandrel until
reaching the nosepiece.
5. Insert the rivet nut fastened to the riveter into the pre-drilled hole
until flush with the work product and pull handles inward to
secure the rivet nut into the hole. If the rivet nut is loose in the
hole, open the handles outward, turn #19 knob clockwise and pull
handles inward until the rivet nut is secure in the hole. Repeat as
necessary until the rivet nut is secure in the hole. See adjustment
instructions if necessary.
6. Turn the #19 knob counterclockwise until the mandrel is removed
from the rivet nut. The rivet nut installation is complete if the rivet
nut is secure from movement in the hole.
CHANGING MANDREL/
NOSEPIECE INSTRUCTIONS
1. Remove and install the mandrel and nosepieces. Always keep
the matched mandrel/nosepiece sets together.
2. Remove nosepiece from #3 sleeve by unthreading the nose
piece counterclockwise. This can be done either by hand or with
the provided wrench if too tight to do so.
13" NUT/THREAD
SETTER KIT
Assembly direction
Page 2
3. Using your thumbnail or tool, press down to depress the #6 inner
hexagonal sleeve that sits within the #3 outer sleeve. This should
expose the lower hex portion of the mandrel.
4. Unthread the mandrel by hand to remove it from the sleeve. Once
the mandrel has been threaded out far enough to clear the #6 hex
sleeve you may release tension on this sleeve collar.
5. Choose the correct mandrel/nosepiece to be installed.
6. Thread the new mandrel into the tool by hand until it approaches
the #6 hex sleeve and fully depress this sleeve to allow the
mandrel to be threaded further until it stops. The mandrel does
not need to be torqued. Release the hex sleeve and allow it to
fully reengage the mandrel. If the mandrel and hex sleeve do not
initially align, rotate the #19 knob while holding onto the mandrel
until it clicks up and reengages.
7. Thread the matching nose piece into the #3 by hand. Torquing the
nose piece is optional.
MNTS13
1508128-14MA