Glem GFLP Manual De Uso página 20

3172618-006 ItIFPE 09/04/15 11:50 Página 20
INCIDENT
The control dial is in position
and the door is still locked.
The control dial is in position
, the oven is cold and the
door is still locked.
I have put the control dial in
position and the door is
unlocked, however symbol
is still lit up and the
remaining time of the cleaning
cycle can be seen on the
display.
The turnspit accesory consists of a rotary
motor, a support hook and a complete spit with
handle. It is used in the following way:
1 Connect the hook (A) to the support (B)
situated at the top of the oven. See figure.
2 Insert the end of the spit in the motor fitting
(C). The other end of the spit is supported
on the hook (A).
3 Set the mode selector to
function.
20
CAUSE
The oven has not cooled down
to the safe temperature.
You have not followed the
instructions to cancel the
operation correctly.
You have not followed the
instructions to cancel the
operation correctly.
Use of Turnspit
or
Warning
Do not forget to unscrew the handle from the
spit before cooking, otherwise it will not be
possible to close the oven door.
SOLUTION
Wait until the temperature
lowers and pilot light
off. Then, cancel the pyrolysis
programme.
1. Turn the control dial to
position and wait for 1
minute.
2. Turn the control dial to
position and wait for 1
minute.
3. Turn the control dial to
position again and wait
until pilot light
Follow the instructions to
cancel the pyrolysis
programme.
C
turns
turns off.
B
A