Top View - Steelcase Sync Trim Replacement for Single Sided Bases Instrucciones De Montaje

®
HEALTH
5.
To install replacement trim on a
single sided base and a double
leg base, begin by lifting cable
manager base (5a) and then
install wallside panel (5b). While
still lifting cable manager base,
install front panel making sure the
front panel and the wallside panel
are fully seated and snap together
where they interface directly
behind the leg (5c).
Lower cable manager base (5d).
Repeat this procedure for other
end of unit.
6.
For the wallside panel on the
single leg unit repeat step 5. For
the freeside panel, install as shown
by engaging the bottom tab with the
slot in the bottom support rail and
then rotating the panel to a vertical
position.
7.
For both single and double leg
units, re-install the top cap and tile
that were removed in step 1.
5a
CABLE
MANAGER
BASE
5b
WALLSIDE
PANEL
5c
ENGAGE TAB ON
BOTTOM SUPPORT
RAIL
WALLSIDE
PANEL
6
FREESIDE
PANEL
5d
CABLE
MANAGER
BASE
FRONT
PANEL

TOP VIEW

FRONT
PANEL
Page 4 of 12
939500407 Rev D