Storage; Protecting The Pump; Storing The Engine - SpeedClean 2200 PSI Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARING UNIT FOR

STORAGE

Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days, follow this
procedure:
1.
Empty cleaning tank as follows:
a.
Disconnect detergent siphon hose connected to
barbed hose fitting on pump. Place end of detergent
siphon hose into suitable container.
b.
Rotate detergent shut-off valve to "On" position
and open the tanks cover. Gravity will empty tank
contents into container.
c.
Reconnect detergent siphon hose to barbed hose
fitting on pump. Add 0.5 liter of clean fresh water to
cleaning tank and close tanks cover.
2.
Flush cleaning system by turning detergent shut-off
valve to "On" position, slide adjustable nozzle forward
to low pressure mode and run pressure washer. Flush
until cleaning tank is empty.Turn its detergent shut-off
valve to "Off" position.
3.
Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark plug wire
from spark plug.
4.
Place the spray gun, nozzle extension, floor brush,
utility brush, brush extension and high pressure hose in
the accessory storage bag.
5.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times.This should remove most liquid in
pump.
6.
Use PumpSaver to prevent corrosion build up and
freezing of pump.
7.
Store unit in a clean, dry area.
SpeedClean™ 2200 PSI Pressure Washer

Protecting the Pump

To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and lubricates pistons and seals.
NOTE: PumpSaver is available as an optional accessory. It
is not included with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver.
To use PumpSaver, make sure the pressure washer is turned
off and disconnected from supply water. Read and follow all
instructions and warnings given on the PumpSaver container.
You must protect your unit from freezing temperatures.
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
Read and follow all cautions and warnings on the
PumpSaver can label.
• Always wear eye protection when using PumpSaver.
PumpSaver will drip from pump after treatment and
will stain wood and concrete.
• Protect surfaces from dripping PumpSaver.
NOTE: If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.

STORING THE ENGINE

See the engine operator's manual for instructions on how
to properly prepare the engine for storage.
16
CAUTION
CAUTION
CAUTION

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

020261-0

Tabla de contenido