®
HEALTH
7.
After holes for floor power are located, install floor power
cable column.
Place each side of cable column next to each other and snap
a push rivet into the top two holes (7a). Place each cable
column floor clip as shown (7b). Mark each hole on each
cable column floor clip (7c). Remove cable column floor clips
and cable columns. Drill 3/8" x 5/8" deep holes and install
floor anchors per manufacturer's specifications (7d).
8.
Position cable column floor clips and cable
columns back into place. Secure clips to floor by
installing two (2) sems screws with lock washer
for each clip.
7a
CABLE COLUMN
7b
CABLE COLUMN
FLOOR CLIP
HOLE FOR
FLOOR POWER
FLOOR ANCHOR
7d
8
PUSH RIVET
7c
MARK HOLE
LOCATIONS
SEMS SCREW WITH
LOCK WASHER
Page 6 of 18
939500408 Rev C