Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
E
N
Carry out periodic analysis of the exhaust combustion gas,
checking the emissions.
G
Periodically replace the gas filter when dirty.
Check that all the components of the combustion head are in
L
a good state, not deformed by the temperature and free from
impurities or deposits from the installation environment or by
I
poor combustion and check also the electrodes are working
efficiently.
S
If the combustion head needs to be cleaned, remove the com-
H
ponents following the procedure indicated below:
Unscrew the two screws (2) and turn the burner around the
pin (1) in the hinge (figure 1).
After pulling out the ignition and ionisation cables (3) from the
terminals of the respective electrodes, unscrew completely
the nut (4) and tighten the screw (5), causing it to move for-
ward inside gas outlet connector (8) in figure 3 to a sufficient
amount to ensure successful disassembly of the mixing unit.
With the same wrench turn the ball joint (6) in the direction
indicated with the arrow, unhooking the lever that moves the
combustion head forward (figure 2).
Slightly raise the gas outlet connector (8) (figure 3). and pull
out the whole mixing assembly in the direction indicated by
the arrow (9) in figure 4. Complete maintenance operations,
proceed with re-assembly of the combustion head, following
the above instructions in reverse order, after having checked
the correct position of the ignition and ionisation electrodes
(see diagram 0002934690).
Note: important
On closing the burner, gently pull towards the electrical panel,
putting them slightly in tension, the two ignition and ionisation
cables, and then arrange them in their places (7) as in figure
2. This will ensure that the two cables do not get damaged by
the fan during the working of the burner.
figura 1
14 / 15
0006081083_200705
figura-2
figura-3
figura-4
Publicidad
