SCHOLTES LVX 9-44 Instrucciones Por Instalación Y El Uso página 15

Salt ......
Salt
The hardness of the water varies from place to place. If
hard water is used in the dishwasher, deposits will form on
the dishes and utensils.
The appliance is equipped with a special softener that uses
a salt specifically designed to eliminate lime and minerals
from the water.
Loading the Salt into the Softener
Always use salt intended for use with dishwashers.
The salt container is located
beneath the lower rack and
should be filled as follows:
1. Remove the lower rack and
then unscrew and remove the
cap from the salt container;
2. If you are filling the
container for the first time, fill
it with water;
3. Place the end of the funnel
(supplied) into the hole and
introduce about 2 kg of salt. It is normal for a small amount
of water to come out of the salt container.
4. Carefully screw the cap back on.
The salt container should be filled up when the low
salt indicator light "E" flashes.
Your appliance will remind you to do so for 5 consecu-
tive wash cycles.
Warning: To prevent rust from forming, we advise you
to load the salt before starting a wash cycle.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjusting the amount
of salt consumed based on the harness of the water used.
This is intended to optimize and customize the level of salt
consumption so that it remains at
a minimum.
Your Local Water Board can supply
the degree of hardness of the
water in your area.
To adjust salt consumption, pro-
ceed as follows:
1) Unscrew the cap from the salt
container.
2) There is a ring on the container with an arrow on it (see
figure to the side), if necessary, rotate the ring in the anti-
clockwise direction from the "_" setting towards the "+"
sign, based on the hardness of the water being used.
It is recommended that adjustments be made in accord-
ance with the following schema:
Hardness of the water
°dH °fH °mmol/l
0 - 10 0 - 17 0 - 1.7
10 – 25 18 – 44 1.8 – 4.4
25 – 50 45 – 89 4.5 – 8.9
> 50 > 89 > 8.9
13
Selector Salt
Autonomy
knob consumption
(cycles/2 kg)
position (grams/cycle)
/ 0
- 20
MED 40
+ 60
/
60
40
25
EN