Error Messages And Error Clearance - Weller MG100S Traducción Del Manual Original

Warranty
Claims by the buyer for physical defects are time-
barred after a period of one year from delivery to the
buyer. This does not apply to claims by the buyer for
indemnification in accordance with §§ 478, 479 BGB
(German Federal Law Gazette).

Error messages and error clearance

Message/symptom
Extraction power missing
„
Loud extraction noises
„
Unit is not running
„
Device does not work
„
We shall only be liable for claims arising from a warranty
furnished by us if the quality or durability warranty has
been furnished by use in writing and using the term
„Warranty".
The warranty shall be void if damage is due to improper
use and if the device has been tampered with by unau-
thorised persons.
Subject to technical alterations and amendments.
For more information please visit
www.weller-tools.com
Possible cause
Pipe system leaking
„
Filter is dirty
„
Turbine speed too low
„
Air speed through extractionarm is
„
too high speed
Thermally switched off
„
Fuse is blown
„
Unit is not properly connected
„
ENGLISH
Remedial measures
Reseal the pipe system
„
change the filter
„
Increase the speed setting
„
only MG100S
Reduce the air speed (reduce air
„
quanitity) only MG100S
Leave the unit to cool down.
„
Switch on again after approx. 3
hours.
Please contact our Customer
„
Service: technical-service@
weller-tools.com
Check the electrical connections
„
GB
17