Dry Vacuum Cleaning; Blowing Function; Interrupting Operation; Finish Operation - Kärcher WD 4.200 Manual De Instrucciones

Start up
 Illustration
Connect accessories.
 Illustration
Plug in the main plug.
 Illustration
Turn on the machine.

Dry vacuum cleaning

Work only with a dry cartridge filter!
Recommendation: To vacuum fine dust,
use the filter bag.
(see description / illustration
 The filling level of the filter bag depends
on the dirt that is sucked in.
The filter bag needs to be replaced
more frequently while sucking in fine
dust, sand, etc.
Clogged filter bags can burst - therefore
make sure to replace the filter bag in a
timely manner!
 Caution: Always use a pre-separator
while vacuuming ashes and soot (order
no. 2.863-139).
Wet vacuum cleaning
 Attach the accessories to vacuum mois-
ture or wetness to the suction pipes or
directly to the handle.
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.
Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from
a gravel bed.
 Illustration
 Turn off the appliance.
 Illustration
)
 Turn off the appliance and disconnect
Empty the container
 Illustration
Storing the appliance
 Illustration
– 8
EN

Blowing function

Connect the suction hose to the blower
connection, this will activate the blower
function.

Interrupting operation

Hook the floor nozzle into the parking
position.

Finish operation

the mains plug.
Remove the appliance head and empty
the reservoir.
Stow away the mains cable, the mains
cable retraction and accessory in the
appliance.
Store the appliance in a dry room.
13