Superior SONIA Manual Del Usuario página 3

SIDE SMOKE OUTLET SONIA / MILLY
This product is supplied with the smoke outlet at the back.
It is however possible to choose to have the outlet on the left of the
stove by purchasing the appropriate kit and proceeding as follows:
- Remove the side panels (see section "REMOVING THE CLADDING" in
the instruction manual supplied with the stove).
- Remove the rear panel (A) from the stove.
- Remove the smoke probe by opening the fastening spring (B) just
slightly.
- Remove the lock screw from the smoke outlet pipe (C) which is
located in the lower part of the pipe itself.
- Remove the rear smoke outlet pipe (D) from its seat (once the pipe has
been removed, it can be considered disposable).
- Install the side smoke outlet connector (E) which is supplied with
the kit and direct it facing right or left as required. Insert it into its
seat making sure to seal it with a gasket and silicone (do not use
cementing agents).
- Fix the smoke outlet connector (E) with the screw which was removed
previously (C).
- Reposition the smoke probe (B).
- Install the curve at 30° (F) which is supplied with the kit to the side
smoke outlet connector (E). Insert it into its seat making sure to seal it
with silicone (do not use cementing agents).
A
B
D
C
B
E
E
DT2012695-00
DT2034098-00
DT2034099-00
C
DT2034100-00
F
DT2034101-00