Publicidad
Idiomas disponibles
Idiomas disponibles
- Reposition the rear panel (A) and install the rear closing plug (G) with
the screws supplied with the kit.
ONLY FOR SONIA
- Remove the knockout (H) which is located in the lower panel you have
chosen, making sure not to scratch or damage the panel.
- Apply the edge covering seal (I) which is supplied with the kit to the
edge of the hole and remove any excess.
ONLY FOR MILLY
- From the left side panel which was previously detached, remove the
knockout [F] which is located on the lower part.
Using the 3 holes on the panel to centre, use a drill with a 6mm bit
being careful not to scratch or damage the panel.
- Apply an edge covering seal [G] with is supplied around the edge of
the hole you obtain in the panel.
- Remove any excess.
a
It is recommended that the seal is blocked with a few drops of
silicone which may be used at high temperatures.
- Replace the casing.
- Proceed to connect the flue following the indications given in the
chapter "GENERAL RULES" in the instruction manual which is
supplied with the product.
a
When the smoke outlet is installed on the side, the MINIMUM
distance of the smoke outlet pipe from the stove is given in
the section "DIMENSIONS" in the instruction manual which is
supplied with the product.
ONLY FOR SONIA
If the smoke outlet is on the right, this measurement is obtained by
putting a pipe with a diameter of 80 mm and length 170 mm (quota H)
between the curve at 30° (F) and the inspection curve.
If the smoke outlet is on the left, do not put any pipe between the curve
at 30° (F) and the inspection curve since the MINIMUM distance is
obtained directly by assembling the 2 curves.
ONLY FOR MILLY
If the smoke outlet is on the right, this measurement is obtained by
putting a pipe with a diameter of 80 mm and length 130 mm (quota H)
between the T joint and the side smoke outlet connector.
If the smoke outlet is on the left, shorten the 30° curve which is supplied
with the kit by 44 mm.
A
G
ONLY SONIA
ONLY MILLY
Ø 6 mm
DT2034102-00
H
I
DT2034103-00
G
DT2034181-00
H
DT2034104-00
Publicidad
