Rules For Safe Operation; User'S Manual - Ryobi CFP-180FM Manual De Utilización

CFP-180FM 17/06/05
GB
F D E
Use only with recommended battery pack (BPP-1817M /
BPP-1815M) and charger (BC-1800 / BC-1815S)
(both sold separately).
CAUTION
Read and follow all Safety Rules and Operating
Instructions before first use of this product.
READ ALL INSTRUCTIONS.

RULES FOR SAFE OPERATION

KNOW YOUR FLUORESCENT LIGHT. Read
■
operator's manual carefully. Learn its applications and
limitations as well as the specific potential hazards
related to this fluorescent light.
REMOVE BATTERY PACK FROM FLUORESCENT
■
LIGHT BEFORE
PERFORMING ANY ROUTINE MAINTENANCE OR
CLEANING.
DO NOT DISASSEMBLE YOUR LIGHT.
■
DO NOT PLACE FLUORESCENT LIGHT OR
■
BATTERY PACK
They may explode.
DO NOT dispose of a worn out battery pack by
■
incinerating. Do not incinerate the battery, even if it is
severely damaged or completely worn out.
The battery may explode in fire.
DO NOT STORE YOUR FLUORESCENT LIGHT IN A
■
DAMP OR WET LOCATION. ALSO, DO NOT STORE
IN LOCATIONS WHERE THE TEMPERATURE MAY
REACH OR EXCEED 40°C (104°F). For example,
outside sheds, vehicles, or metal buildings in
the summer.
DO NOT PERMIT CHILDREN TO USE FLUO-
■
RESCENT LIGHT UNSUPERVISED. It is not a toy.
The temperature of the bulb can become hot after
being on for an extended period of time. This hot
temperature may cause burn injury if touched.
KEEP WORK AREA CLEAN. Cluttered areas and
■
benches invite accidents.
AVOID DANGEROUS ENVIRONMENT.
■
KEEP LIGHT DRY, CLEAN, AND FREE FROM OIL
■
AND GREASE. Always use a clean cloth when
cleaning. Never use brake fluids, gasoline, petroleum-
based products or any strong solvent to clean your light.
STAY ALERT. Watch what you are doing and use
■
common sense. Do not rush.
CHECK DAMAGED PARTS. Before further use of
■
this light, a part that is damaged should be carefully
checked to determine that it will operate properly and
perform its intended function. Do not use fluorescent
light if it does not function properly.
13:34 Page 3
I P NL S DK
English
REPLACING BULB OR
NEAR FIRE OR HEAT.
N FIN GR H CZ RUS
SAFETY RULES FOR FLUORESCENT LIGHT
WARNING
Do not operate fluorescent light or charger near
flammable liquids or in gaseous or explosive
atmosphere. Internal sparks may ignite fumes.
WARNING
Lens and bulb become hot during use.
During or immediately after use, don't lay fluorescent
■
light flat on lens surface.
Handle fluorescent light with care around any
■
flammable surface.
If bulb has been lit, let fluorescent light cool for
■
several minutes before changing bulb.
Do not use or permit use of fluorescent light in bed or
■
sleeping bags. A burn injury could result.
DESCRIPTON
1. BATTERY PACK (NOT INCLUDED)
2. GROOVES
3. TO REMOVE: DEPRESS LATCH TO RELEASE
BATTERY PACK
4. SWITCH TRIGGER
5. TO LOWER
6. TO RAISE
7. HANGER
8. SCREW
9. PULL LENS COVER FORWARD TO REMOVE
10. RUBBER CUSHION
11. LENS COVER
12. FLUORESCENT TUBE
13. FLUORESCENT TUBE SOCKET AREA
TO INSTALL/REMOVE BATTERY PACK
See Figure 1.
Begin with a fully charged battery pack.
■
TO INSTALL: Align raised ribs on battery pack with
■
grooves on bottom of fluorescent light, then install
battery pack to fluorescent light as shown in figure 1.
Make sure the latch on battery pack snaps in place
and battery pack is secured to fluorescent light before
beginning operation.
TO REMOVE: Depress latch located on front of
■
battery pack (1) to remove battery pack. Pull on
battery pack (2) to remove from fluorescent light.
3
RO PL SLO HR TR