Össur Iceflex Endurance Guia De Inicio Rapido página 3

ENGLISH
ICEfLEx ENduraNCE
®
suction suspension sleeve
1. Measure circumference 15cm (6") above midpatella and choose the
correct size (figure 1). See sizing chart below.
2. Turn the Iceflex sleeve inside out half way, with silicone of distal end
half-exposed. Stretch the sleeve over the brim of the socket and roll
distal end completely down (figure 2). Make sure the longitudinal
stretch knee area is centered over the patella.
3. Roll down upper part of the sleeve until socket brim is completely
exposed (figure 3). Step into the socket and make sure the residual
limb is positioned correctly in the socket. Roll the sleeve up with
both hands. Do not pull on the edges as this may place strain on
the skin.
4. To take full advantage of the Iceflex sleeve features, correct
alignment is important (figure 4). The knee area must be centered
over the patella and the vertical support lines along the side of the
sleeve should be in the M, L position.
5. Wash the Iceflex sleeve daily, especially on the inside (figure 5). To
do so, remove the sleeve, turn it inside out and use Iceross clean
and simple soap. Be sure to rinse with plenty of water, and wipe dry
with a towel. Alternatively the sleeve can be rolled down onto the
socket and washed.
6. The Iceflex sleeve can also be machine washed (40-60°C/Warm)
(figure 6). Turn the sleeve inside out during washing. Rinse
thoroughly with clean water to remove all soap residues. Switching
between two Iceflex sleeves adds convenience and serves as a
security precaution.
Size Measurement cm
35 35-41cm
41 41-49cm
49 49-55cm
55 55-62cm
62 62-69cm
All Iceflex Endurance sleeves are 35 cm long (14").
WarraNTY: Iceflex Endurance comes with a 90-day warranty against
defects in material and workmanship.
Measurement inches
13 3/4 - 16"
16 - 19 1/4"
19 1/4 - 21 3/4"
21 3/4 - 24 1/2"
24 1/2 - 27 1/4"
4