Operation; Select Operating Mode; Preselecting The Rotation Speed; Switching On And Off - Parkside Performance PKHAP 20-Li A1 Traducción Del Manual De Instrucciones Original

Tool/chuck
♦ Grease the tool holder q slightly before
inserting the tool .
♦ Check that the tool is properly locked by pulling
it . The system has radial play because of the
design .
Removing a tool
♦ Pull the locking collar w backwards and
remove the tool .

Operation

Select operating mode

WARNING!
► Do not press the function selector switch 1
until the appliance has come to a complete
standstill . Switching between functions while
the tool is still rotating can damage the appli­
ance .
Function selector switch
♦ Press and hold the release button
function selector switch 1 . Turn the function
selector switch 1 so that the required symbol
engages at the arrow mark:
Function
Drilling
Hammer drilling
Chisel position adjustment
Chiselling
■ │ GB │ MT
50
Adjusting the chisel position
You can rotate the tool to the required position for
chiselling using this function .
♦ Turn the function selector switch 1 to the
position .
♦ Turn the tool in the tool holder q to the
required position .
♦ Turn the function selector switch 1 to the
position for the chiselling function .

Preselecting the rotation speed

You can use the rotation speed preselector dial 8
to preselect the rotation speed . Level 1 (low rota­
tion speed) up to level 6 (high rotation speed) .
Work out the correct settings by carrying out a test:
– Level 3–6: high speed: for hammer drilling/
chiselling in concrete or stone
– Level 1–3: low speed: for drilling in steel or
wood

Switching on and off

on the
Switching the appliance on
♦ Press the ON/OFF switch 2 .
Switching the appliance off
♦ Release the ON/OFF switch 2 .
Symbol

Changing the direction of rotation

♦ Change the direction of rotation by pressing
the rotation direction switch 3 towards the left
or right .
PKHAP 20-Li A1