Replacing Components - AFG EM70/40 PCG Serie Instalación, Uso, Mantenimiento

- Knob of gas tap or valve not pressed a.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT)
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Defective burner (gas outlet holes clogged).
GAS OVEN
THE PILOT BURNER DOES NOT LIGHT
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Igniter defective or not properly connected.
- Igniter or igniter wire defective.
PILOT BURNER GOES OUT DURING USE
Possible causes:
- Insufficient gas supply pressure.
- Defective gas tap or valve.
- Defective thermocouple or insufficient heating.
- Thermocouple incorrectly connected to gas tap or
valve.
- Knob of gas tap or valve not pressed a.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT)
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Defective burner (gas outlet holes clogged).
HEATING CANNOT BE ADJUSTED
Possible causes:
- Defective gas valve.
ELECTRIC HOB
THE HOTPLATE DOES NOT HEAT.
Possible causes:
- Hotplate defective.
ELECTRIC OVEN
THE APPLIANCE DOES NOT HEAT.
Possible causes:
- Temperature thermostat defective.
- Heating elements defective.
- Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED
Possible causes:
- Temperature thermostat defective.

21. REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS
SHUT THE
AND/OR SWITCH THE APPLIANCE OFF AT
THE MAIN
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS AT
CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS HOB
REPLACING THE GAS TAP.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE PILOT BURNER AND
THERMOCOUPLE.
- Remove the control panel.
- Remove the panstand grids and burners.
- Remove the 3 screws securing the venturi to the
hob and pull the venturi out by approx. 10 cm.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
GAS SOLID TOP RANGES
REPLACING THE GAS TAP AND PIEZO IGNITER.
- Remove the control panel.
27
GAS SHUT-OFF
SWITCH INSTALLED
REPLACING AN ELECTRICAL
VALVE