Continuous Washing (*Optional); Automatic Cycle Start-Up; Removing The Integral Filter; Emptying The Dishwasher - MBM LS526 Manual Del Usuario

• This is an extended cycle; the time varies according to the model.
• The cycle duration may be varied as required by pressing START (3) during the wash cycle, to
interrupt the wash and start the rinse phase.
This function is used to make the chosen cycle start automatically when the door is closed. To enable,
proceed as follows (Fig.6):
•
With the appliance on and the door open, press and hold (for at least five seconds) START (3) until
AS appears on the display.
•
To disable the function, with the door open press START (3) again for five seconds.
•
Move the washing and rinsing arms at right angles to the edge of the door (Fig.7).
•
Lift each semi-filter by the relative handle.
•
Switch the dishwasher off.
•
Remove the integral filter ( Fig.7A ).
•
Pull up and remove the overflow pipe ( Fig.8B ).
•
Wait for the tub to empty completely.
•
If necessary, extract the tub filter and clean ( Fig.8C ).
•
If present, remove the integral filter ( Fig.7 ).
•
If present, remove the overflow by pulling upwards ( Fig. 9 ).
•
Close the door.
•
Select the cycle dr
•
Press START (3) to start the cycle.
•
The machine runs a drain cycle with self-cleaning (*where foreseen) and then switches off.
•
If necessary, extract the tub filter and clean ( Fig.8C ).
•
Press ON/OFF (1), on the DISPLAY (4) the central segments will light up, indicating that the
machine is powered.
I
n machines fitted with water softener, when the warning 'SLT' appears you should add salt to the
relative container; proceed as follows:
•
Remove the basket from the machine.
•
Remove the integral filter ( Fig. 7 ).
•
Unscrew the cap on the salt container ( Fig. 11 ).
•
Pour in approx. 700g of large-grain kitchen salt, using the funnel supplied. (when filling for the first
time, fill the tank firstly with water)
•
Close the container firmly.
INSTRUCTION MANUAL FOR DISHWASHERS
4.5

Continuous washing (*optional)

4.6 Automatic cycle start-up

4.7 Removing the integral filter

4.8 Emptying the dishwasher

4.8.1 Appliances with no drain pump

4.8.2 Appliances with drain cycle (*optional)

4.9 Turning the dishwasher off

4.10 Resin regeneration (*optional)

UK
Page 7 of 12