EFI ES-2000 Guia De Instalacion página 3

Setup
The EFI ES-2000 setup is performed by connecting the EFI ES-2000 to a computer.
T EFI ES-2000
O SET UP THE
1 Connect the EFI ES-2000 to the computer.
Connect the USB cable of the EFI ES-2000 to a free USB port on your computer, or to a
USB hub that features a separate power supply.
Because of its power requirements, the EFI ES-2000 will not work if it is plugged into
N :
OTE
the USB port on your keyboard.
2 Start the application that uses the EFI ES-2000.
For more information, see the documentation that accompanies the application.
Status indicator lights
The EFI ES-2000 is equipped with lights that indicate device status. When the instrument is
used with Fiery software, the lights have the following behavior.
Lights
Off
Solid white
Blinking blue
Blinks green twice
Blinks red twice
If the EFI ES-2000 is used in EFI ES-1000 compatibility mode (as a replacement for
N :
OTE
the EFI ES-1000), the lights may not operate.
Measuring color samples
You can measure color samples using two different methods: single-patch measurement and
strip measurement.
EFI ES-2000 calibration
Before starting to measure color samples, you are prompted to place the EFI ES-2000 on the
calibration cradle. White point calibration is used to calibrate the spectrophotometer and
ensure consistent measurements.
Status
The EFI ES-2000 is not connected to your computer or the
software is not running.
The EFI ES-2000 is connected but needs an initial calibration or
the instrument calibration failed.
The EFI ES-2000 is ready to take measurements.
The measurement was successful.
A calibration error or measurement error occurred.
3